speeddownloaditalia.blogg.se - Why is my taskbar so thick

DeFelsko recommends that customers establish calibration intervals based upon their own experience and work environment. For organizations with re-certification requirements, instruments may be returned at regular intervals for calibration. CertificationĪll probes include a Certificate of Calibration. Next, lay the included plastic shims onto a bare surface and measure them individually to ensure the Gage measures a known thickness within tolerance. Measure your uncoated part first! This quick zero-check determines if a Calibration Adjustment is needed for your substrate. This film, while usually removed before using the instrument, can be left in place to protect against paint overspray. The LCD is covered with a thin plastic film for protection against fingerprints and other marks during shipment. We recommend attaching and wearing the supplied wrist strap. Replace it when the instrument is not in use to protect the probe. Some PosiTector 6000 models are shipped with a protective plastic cap over the probe. If memory is ON while continuous measurements are being taken, only the last value on the display (when the probe is lifted) is stored into memory.

Lift probe AT LEAST 2 INCHES (5cm) from the surface between measurements - OR - leave probe on the surface in the same location for continuous measurements.

When a valid measurement is calculated, the Gage BEEPS twice and the measurement is displayed.

Place the probe FLAT on the surface to be measured.

Power-up Gage by pressing the center navigation button.

Remove the protective plastic cap (if supplied) from probe.

To preserve battery life, it powers-down after approximately 5 minutes of no activity. The PosiTector 6000 powers-up when the center navigation button is pressed.

Nylon carrying case with shoulder strap.

Gage (in addition to above Probe accessories):

Protective Cap for Probe (some probes only).

Certificate of Calibration traceable to NIST or PTB.

Protective rubber holster with belt clip.

N probes use the eddy current principle to measure the thickness of non-conductive coatings on non-ferrous metals.įN probe combine the full abilities of both the "F" and "N" probes. Principles of Operationį probes use the magnetic principle to measure the thickness of non-magnetic coatings on ferrous metals. It consists of a body (Standard or Advanced) and probe (Built-in or Separate). The PosiTector 6000 hand-held, electronic instrument non-destructively measures the thickness of coatings on metals, quickly and accurately.